APA Open Community

APA Members at Roundtable Discussion

 View Only

  • 1.  Laser engraving

    Posted 05-26-2023 16:44

    This started today and is progressively getting worse. Any ideas what could be going on, belts are tight, bearings appear fine. Thanks in Advance!!



    ------------------------------
    Megan Raymond
    Owner, Raymond's Trophy & Awards
    Bakersfield, CA
    661-323-4015
    ------------------------------
    Netsoft Studio


  • 2.  RE: Laser engraving

    Posted 05-27-2023 07:27

    Not sure what type of laser you have? We have Epilog machines and have seen this in the past.  It was a fairly easy fix by replacing the X-axis flex cable or the X-axis encoder strip.



    ------------------------------
    Van Brogden
    President/Owner
    M & M Engraving & Graphics
    Winston Salem NC
    336.558.8963
    ------------------------------

    Netsoft Studio


  • 3.  RE: Laser engraving

    Posted 05-27-2023 09:27

    Megan,

    Looks to me like it is a Y axis issue. Clean & possibly lubricate Y axis components.  As Van suggested, different manufacturer's systems might require different solutions; so,  I think you'll get better input if you give us  make/model of your laser.



    ------------------------------
    Roy Brewer roy@engravingconcepts.com
    Engraving Concepts
    Arlington TX
    817.460.8122
    ------------------------------

    Netsoft Studio


  • 4.  RE: Laser engraving

    Posted 05-30-2023 15:57

    We did some lubrication and it seemed to do the trick!!! Thank you!!!



    ------------------------------
    Megan Raymond
    Owner, Raymond's Trophy & Awards
    Bakersfield, CA
    661-323-4015
    ------------------------------

    Original Message
    Netsoft Studio


Related Content