APA Open Community

I am making a cone adapter for the Trotec Laser, which i do not have access to. There is a 10mm thread that i plan on my adapter spinning onto, as well as a set screw. But i do not know the pitch of this thread. M10-1  or   M10-1.25    or   M10-1.5

Any contact that may help me would be appreciated.  Thanks Fred

ANYONE IN THE SURROUNDING AREA WITH A TROTEC LASER?  Near Rancho Cucamonga, CA

I am making a cone adapter for the Trotec Laser, which i do not have access to. There is a 10mm thread that i plan on my adapter spinning onto, as well as a set screw. But i do not know the pitch of this thread. M10-1  or   M10-1.25    or   M10-1.5

Any contact that may help me would be appreciated.  Thanks Fred

Fred,

Were you able to get an answer to this. I have a Trotec and the rotary if you need something to be measured, you're more than welcome to call.

ANYONE IN THE SURROUNDING AREA WITH A TROTEC LASER?  Near Rancho Cucamonga, CA

I am making a cone adapter for the Trotec Laser, which i do not have access to. There is a 10mm thread that i plan on my adapter spinning onto, as well as a set screw. But i do not know the pitch of this thread. M10-1  or   M10-1.25    or   M10-1.5

Any contact that may help me would be appreciated.  Thanks Fred